1. Place toolbox on truck bed and center.

2. Make sure foam seal on bottom is not deformed by dragging (flatbed).

3. Make sure truck is on level ground.

4.Open doors and slide tool tray about 1 foot to one side.

5.From the other side, mark where holes are on bed (sides, pick up).

6. Do the same with the other side.

7. Remove Quick Draw toolbox and drill four 3/8” holes.

8. Replace toolbox and align holes in toolbox with holes in bed.

9.Insert 1-1/4” x 3/8” grade 5 zinc-plated bolts.

10. Place a 3/8” lock washer and a 3/8” grade 5 nut.

11. Torque nut to 70 ft/lb.

1. Place toolbox on truck bed and center.

2. Make sure foam seal on bottom is not deformed by dragging (flatbed).

3. Make sure truck is on level ground.

4.Open doors and slide tool tray about 1 foot to one side.

5.From the other side, mark where holes are on bed (sides, pick up).

6. Do the same with the other side.

7. Remove Quick Draw toolbox and drill four 3/8” holes.

8. Replace toolbox and align holes in toolbox with holes in bed.

9.Insert 1-1/4” x 3/8” grade 5 zinc-plated bolts.

10. Place a 3/8” lock washer and a 3/8” grade 5 nut.

11. Torque nut to 70 ft/lb.